Power supply The FS-1000E can be powerd from either type-3 alkaline battery ×2 pcs, or an external power source 9~30VDC depending on the application.
Optional power source can be from a long life lithium battery. External output to a security system
Equipped with a form A (N/O) open collector output, FS-1000E can be connected to a security control panel. Alternatively the output signal can be used to initiate a warning device e. g. bell, siren etc., when used with an external DC power supply. Operation set-up by detection timer
The alarm will be activated only when the sensor detects a flame (ultraviolet rays) in accordance with the detection timer. The 3
following detection times are selectable by a slide switch located on the sensor body.
H: 0.2sec. M: 1sec. L: 6sec. Other functions
● The internal alarm sounder output is greater than 80dB at 3.3ft. (1m) in front of the sensor. The internal sounder can be disconnected by cutting a jumper wire if required when using an external DC power supply.
● Compact design enables FS-1000E to be installed at any location. Easy separation of the sensor unit from the base simplifies installation and maintenance.
● Low battery
When using a battery power source, low battery condition is annunciated by an internal buzzer and external LED.
● Power up
When power is turned on, an alarm sound is activated. If no alarm sound is activated, check the power source.